The
NQ-900 Wireless Z-Wave Router is a consumer electronics
device used for home monitoring and security. The
Gateway communicates with electronic sensors and devices
located throughout the home using wireless Z-Wave
communications. The gateway can also function as a
normal Wi-Fi router, providing internet access and
alowing the user to manage Z-Wave enabled
devices via PC, laptop or smart phone.
The
Gateway communicates with electronic sensors and devices
located throughout the home using wired communications
and connect to the outside world using broadband.
For
NQ-900, NorthQ is hardware solution provider which is
included the Hardware boards and its driver.
Key Selling:
Great price/performance
Broadband Router with Wi-Fi 802.11G
Built in Z-Wave sensor interface module for home automation
control
Built in web interface for controlling Z-Wave
devices
Two USB ports for adding USB modem dongle, external hard disk
etc.
Built in Ethernet and Wi-Fi 802.11G
connection
Compatible with Danish Saving Trust’s
portal
Compatible with EU Alarm surveillance
portal
WPS button for easy WIFI set-up between camera and Z-Wave
gateway
Fully supports Huawei E220/E230 USB MODEM
The
technologies used by the Gateway include:
(2) USB 2.0 Host ports 10/100
LAN
Port
10/100 WAN
Uplink
Port
Broadcom 4318E based WiFi w/SiGe SE252180 FEM (capable
of 26dBm peak power) TBD 2
internal Airgain Maxbeam 30 antennas
Special WiFi Requirements
MSSID (2) with first SSID set to a default SSID and WEP
security
WPS
WMM
Population option for ZWave controller (by optional
daughter board)
Memory: 16/32
Networking: LAN WAN
(Uplink port)
Wireless Communications:
ZWave on-line programming (optional ) Wired
Communications:
Processor: Broadcom BCM5354
1.1
Main
features –
Processor
Board:
Hardware:
BCM5354
processor with16MB Flash and 32MB SDRAM, Linux 2.4 BSP
Ready Two
Ethernet port with RJ45 connector.
Front Panel LEDs ZWave
Transceiver Two
USB 2.0 ports
WPS button (big button)
Reset Button
Power In connector
Internal antenna for WiFi and Z-Wave.